Morel Elate Carbon Pro 62A 2-Way Component Speakers 6.5" 16.5 cm

The evolution of the iconic Elate line continues to push the boundaries of performance. From the outset the Elate Carbon Pro was developed to be more than just a new set of speakersit was designed to bring our customers closer on their quest of an immersive musical experience that will leave you breathless.

Elate Carbon carries on the tradition of high power, high fidelity speaker systems, yet takes a leap forward in sound performance. The new Pro series is highlighted by the Elate Alto cavity-back tweeter a high-resolution design borrowing its architecture from the Supremo Piccolo. Combined with the new carbon fiber and Rohacell cone midrange and woofers, performance is breathtaking in detail, even at extreme volume levels.

No other speaker system fully envelops high-resolution and high power handling like the new Elate Carbon Pro.

HANDCRAFTED ACUFLEX SOFT DOME
A specially engineered damping compound applied to the soft domes of specific Morel tweeters and midranges. The combination of these materials creates a diaphragm that exhibits controlled canceling break up (accurateflexing), meaning each break-up mode is counteracted by another in the opposite direction. This cancellation of break-up modes leaves nothing but the pure, natural sound Morel tweeters and midrange are famous for.

HEXATECH ALUMINIUM VOICE COIL
Made from 100% aluminum wire shaped like a honeycomb, the Hexatech voice coil reduces air gaps in the coil windings, thereby increasing efficiency by up to 20%. Being lightweight, Hexatech voice coils are largely responsible for the extraordinary fast transient response Morel drive units are known for.

NEODYMIUM MAGNET
The most powerful magnet available, neodymium enables Morel to create physically compact speakers, such as tweeters and midrange, that fit in very limited spaces without limiting the quality of sound.

CARBON FIBER CONE
Derived from the drivers of our award-winning fat lady speaker system, this cone design is comprised of two exterior carbon fiber skins sandwiching a layer of Rohacell, a high strength, featherweight foam. The combination forms a cone that is light, strong and properly damped for naturally uncolored audio reproduction.

EVC MOTOR
Morel speakers with EVC technology utilize voice coils that are up to three times larger than those used in conventional loudspeakers. The EVC design moves the magnetic drive system within the voice coil, eliminating stray magnetic flux by effectively directing all the magnetic energy to the voice coil. The result is an ultra-efficient and powerful design, that is highly compact with efficient heat dissipation and reduced cone breakup for lower distortion.

BUILD AN ACTIVE SYSTEM
Passive crossover systems are not included. Morel designed these Elate Carbon speakers to be neutral, without coloration, so that you can use your active crossover to craft exactly the right sound for you and your vehicle. You'll need an active crossover to use these speakers. If you would like to use passive crossovers with this system, optional Morel MXT280C crossovers are available.



TECHNICAL SPECIFICATIONS
16.5 cm (6.5") 2-Way Component System
includes two woofers and two tweeters (crossovers required)
6-1/2 3-layer carbon fiber/Rohacell woofer cone with butyl rubber surround
1.1" Elate Carbon Alto Acuflex-coated silk dome tweeter
Cast aluminum basket
Power Handling 180/1000 Watts
Impedance 4 Ohms
Sensibility 87dB
Frequency Response 30Hz - 25kHz

Morel car audio catalogue
Elate carbon series manual

To ensure compatibility, we recommend that the parts pictured in our listing are compared to the actual parts in your vehicle before you make your purchase. If still unsure please contact us via email system so we can advise before you make your purchase.