-
MenuBack
-
Accessories
-
-
INSTALLATION ACCESSORIES
- 12V / 24V / 220V Voltage Dropper
- Active System Adapters
- Antenna Adapters
- Audio AUX Interface
- Braided Sleeve
- Cables & Connectors
- CAN Bus Interfaces
- Car Care
- Facia Plate 1-DIN / 2-DIN
- FM/GPS/TV Antenna
- Fuse Holder
- Infodapter Interfaces
- Line Output Converter
- Noise Filter
- Noise Insulation
- OEM Parking Retention
- OEM Reverse Camera Retention
- Retrofit Cables
- Speaker Adapters
- Speaker connector
- Steering Wheel Interface
- Tools
- USB Retention Socket
-
-
-
-
Security Systems
-
-
-
Used Parts
-
-
-
-
-
Car Audio & Multimedia
-
-
-
-
Marine Audio
-
-
-
Radios RetroSound
-
-
-
-
Multimedia
-
-
-
Noise Insulation
-
-
-
-
Speaker Rings
-
-
-
Fascia Plates
-
-
-
Camera nterfaces
-
-
Camera & Video Interfaces
- Alfa
- Aston Martin
- Audi
- Bentley
- BMW
- Cadillac
- Chevrolet
- Chrysler
- Citroen
- Dacia
- Dodge
- Ferrari
- Fiat
- Ford
- Honda
- Hyundai
- Infiniti
- Iveco
- Jaguar
- Jeep
- Kia
- Lamborghini
- Lancia
- Land Rover
- Lexus
- Maserati
- Mazda
- Mercedes
- Mini
- Nissan
- Opel
- Peugeot
- Porsche
- Renault
- Rolls Royce
- Seat
- Skoda
- Smart
- SsangYong
- Suzuki
- Tesla
- Toyota
- Volkswagen
- Volvo
-
-
-
-
CarPlay & Android
-
-
-
-
-
CarPlay Wireless
-
-
-
Parking
-
-
-
-
Parking Sensor
-
-
-
monitors
-
-
-
DVR Cameras
-
-
-
acessories
-
-
-
Lighting
-
-
LED Lighting
-
-
-
-
Xenon Lighting
-
-
-
Halogen Lighting
-
-
-
Ballast
-
-
-
Media
-
ESX DC500 Power Capacitor 0.5 Farad
ESX DC500 Power Capacitor 0.5 Farad
Power capacitors represent a very important component within a high-performance car audio system. The increasingly power-hungry board electronics of newer vehicles allow usually no large power reserves for the amplifiers and when you turn the air conditioning or seat heating the system voltage suddenly drops below 10 volts until the electrical system stabilizes after a while. These drop downs make themselves immediately noticeable as power interruptions in the music playback and the bass and lower frequencies skips temporarily. This can also happen vice versa, if the amplifier reproduces a very intense and strong bass section in a song, this can cause dropouts in the on-board voltage and the headlights start to flicker.
For these reasons, it is indispensable to use a power capacitor for sound installations above the 500 watt limit, because this device stores and buffers the voltage and supply the amplifier with the necessary power during voltage drop downs. Then, the electrical system is protected and music playback is not disturbed. Power Caps are usually just between the vehicle battery and amplifier.
The compact DC500 power capacitor with integrated distribution block provides more consistent power, sound enhancement and bass performance for the amp. With true 0.5 Farad capacity, it catches down unwelcome voltage fluctuations and stabilizes the entire sound system. Thanks to the integrated distribution block, the DC500 is versatile and can be installed anywhere due to its small dimensions.
0.5 FARAD POWER CAPACITOR WITH INTEGRATED DISTRIBUTION BLOCK
Operating voltage 12 - 15 V DC
Operating temperature -20 ~ 60° C
Digital voltmeter with 3 digits
Connection for remote turn-on
Sturdy acrylic holders
Dimensions: Ø 6,5 x 13,6 cm
Distribution Block
1 x Plus 16 mm² IN / 2 x 10 mm² OUT
1 x Minus 16 mm² IN / 2 x 10 mm² OUT
Owner´s manual
To ensure compatibility, we recommend that the parts pictured in our listing are compared to the actual parts in your vehicle before you make your purchase. If still unsure please contact us via email system so we can advise before you make your purchase.
You might also like